DPS Telecom NetGuardian 832A G5 User Manual page 11

DCP Port Enter the DCP Port for this NetGuardian. (1-8 serial otherwise UDP/IP Port)
DCP Protocol
Get History Select the Download button to download the logs for all D-Wire sensors (Only
Erase History Check this box to erase all logs for each D-Wire sensor. (Only available with the
Modbus Unit ID User definable ID number for the Modbus feature. Value can range from 1-255 (0
Modbus Port
Silence non- Check the box to silence alarms not applicable to your configuration. Example:
reportable This NetGuardian is not setup to send SNMP traps. Check this box to avoid
system alarms receiving a failure notification for system alarm 13 (SNMP Trap not sent).
LCD Point Check this box to have the front panel LCD operate in "Point Mode". In this mode,
Mode only the points in alarm are displayed on the screen, instead of the full alarm
descriptions. Point numbers for discrete alarms, analog threshold crossings, and
latched relays will appear on the LCD. See hardware manual for details.
DNP Address This is the DNP3 polling address of the NetGuardian. This value can range from 0
DNP TCP Port This option allows you to select the port for DNP3 polling over LAN. Set to "0" to
Persist event
log over soft
reboot
Enable If this is checked, the NetGuardian will reboot itself 29 minutes after the scheduled
hour. At the top of the hour of the scheduled reset, the NetGuardian will show a
warning on the web interface and display the countdown until the reset in minutes.
System alarms will be saved across the reset. If "Persist event log over soft
reboot" is checked, the event log will be saved across the reset as well.
Frequency How often you would like the unit to perform a maintenance reset. You can select
Day of week, Select on which weekday, day, or month to reset. This setting is relative to the
day, or month frequency option. If Frequency is set to monthly, the NetGuardian will skip months
on which the reset date is not valid for the month. For example, if the reset day is
31, it will not activate the reset in September or February. This field is not used
Hour of day Which hour of the day you would like the NetGuardian to perform the maintenance
Note: DCPe added to the list of DCP protocols.
Choose between DCPx, DCPf, or DCPe.
available with the D-Wire top board hardware build option).
D-Wire top board hardware build option).
Modbus port for this NetGuardian.
Check to save the event log over a soft reboot.
Yearly, Monthly, Weekly, and Daily.
when frequency is set to Daily.
reset. The reset will be perform 29 minutes after the top of hour.
Table 3.A. System fields
= Disabled)
-
65519.
disable DNP3
6