DPS Telecom NetGuardian 832A G5 User Manual page 66

61
Configure your Serial/Data Ports through the Edit > Ports screen
Use the following steps to configure your DSCP device settings:
1. From the Edit > Ports menu, select the 'DSCP' type for the serial port the DSCP device is connected
to.
2. From the Edit > DSCP menu, input a value for the Update Frequency (the rate the sensor will report
data back to the host NetGuardian unit).
3. Select the type of DSCP device.
4. Click 'Submit Data' to save your settings.
5. Reboot the NetGuardian.
6.Once the NetGuardian comes back online, give it a few moments to initialize the wireless radio. You
will then press and hold the sync button on the wireless transmitter until you see the LED become lit.
Once this is done, the NetGuardian and Wireless Transmitter will become synchronized. If you refresh
the DSCP page, you should now see an address value in the "Module Address" fields.
7.Now configure the Analog Channels: See next page for examples of specific values.