Configure The Accumulation Timer - DPS Telecom NetGuardian 832A G5 User Manual

43
2.13

Configure the Accumulation Timer

Fig. 2.24. Define the Accumulation Timer settings to send an Accumulation Event alarm
Field
Display and Point Reference
Point Description
Point Status
Event Threshold
Accumulated Time
Accumulated Since
Reset Accumulation Timer
The NetGuardian's
Accumulation Timer
state to send an Accumulation Event system alarm once the total time exceeds a defined threshold.
Refer to Table 2.I for field descriptions.
Use the following steps to configure the accumulation timer settings:
1. Go to the menu and select the Accum. Timer link, see Figure 2.24.
Edit
2. In the
Display Reference
3. In the
Point Reference
4. In the
Event Threshold
alarm state in order to send an accumulation event system alarm.
5. Click
Submit Data
!
Hot Tip!
The ,
Point Description
configurable. These fields will show the corresponding data of the point you configure for the
accumulation timer after you have hit the
Indicates which alarm point is to be monitored
The user-defined description of the monitored alarm point.
The current status of the monitored point.
The amount of time allowed to accumulate before the "Accumulation Event"
system alarm is set. Maximum is 45 days.
The total time the monitored point has been in ALARM state.
Indicates the last time the accumulation timer was reset.
Placing a check mark here will reset the timer when the user presses the
Submit button.
Table 2.I. Fields in the Accumulation Timer screen
keeps a running total of the amount of time a point is in an alarm
field enter the corresponding display number to be monitored.
field enter the corresponding alarm point to be monitored.
row enter the appropriate running total days, hours and minutes a point is in a
to save the configuration settings.
Only check the
Reset Accumulation Timer
,
Point Status Accumulated Time
Submit Data
Description
box if you wish to reset the timer.
, and
Accumulated Since
button.
fields are not