DPS Telecom NetGuardian 832A G5 User Manual page 67

Configure your external DSCP devices through the Edit > DSCP screen
Advanced Configuration and Details:
Module Address High
Module Address Low
Reset High & Low
Addresses
Update Frequency
Type
Fuel Level Change Detection (Battery Propane Sensor Only)*
Read Frequency
Level Threshold
Generator Running Detection (Battery Propane Sensor Only)*
Gen. Running Frequency
Generator Point Reference
*Note: Generator Run and Level Detection features are designed to detect changes faster while
maximizing
battery life. They are entirely optional to use.
Refer to the Analog Parameters section for detailed instructions on analog channel configuration.
Module Configuration
4-byte identification address that is automatically acquired when the
DSCP device is sync'd with the NetGuardian.
4-byte identification address that is automatically acquired when the
DSCP device is sync'd with the NetGuardian.
Resets the Module Address High and Module Address Low.
The rate that the DSCP device will collect information from the sensor.
The specific type of DSCP device (Propane Monitor, Track Monitor,
The DSCP device will read the propane level at this frequency and will
remember the last read value. Input '0' to disable this feature.
If the propane level reading differs by the Level Threshold value from the
previous reading, then the most recently read value will immediately be
sent to the NetGuardian once.
When the specified alarm point (from Generator Point Reference) is
set, the timer value for Generator Running Frequency will override the
timer value for Update Frequency (under Module Configuration). This
takes effect after the next update.
Specify the Display and Point attached to Gen. Running Frequency.
Input '0' to disable this feature.
etc...).
62