Snmpv1 Notification Setup; Snmpv3 Notification Setup - DPS Telecom NetGuardian 832A G5 User Manual

33
"user@yourdomain.com" for POP before SMTP authentication.
3. Click Submit Data to save your changes.
4. Click on the Edit menu > System link.
5. In the Name field type the name of the address you want to receive notifications from the
NetGuardian (the part of the email address coming before the @ symbol - user@yourdomain.com).
6. In the Location field type the domain of the address you want to receive notifications from the
NetGuardian (this is the part of the address coming after the @ symbol - user@yourdomain.com).
7. Click Submit Data to save the new system information settings.
Authenticated SMTP Emails:
To send authenticated SMTP email notifications:
1. In the Pin/Rcpt field enter the password for the email acount that notifications willl be sent to.
2. In the Phone/Domain field, input the address email will be sent to, in the format
"user:yourdomain.com" (Note the ':' in place of '@').
3. Click Submit Data too save your changes.
4. Click on the Edit menu > System link.
5. In the Name field, type the name of the address that you want to receive notifications from the
NetGuardian (the part of the email address coming before the @ symbol - from@fromdomain.com).
6. In the Location field type the domain of the address you want to receive notifications from the
NetGuardian (this is the part of the address coming after the @ symbol - from@fromdomain.com).
2.6.6

SNMPv1 Notification Setup

The SNMPv1 notification feature allows you to view alarm status from multiple SNMP managers in
addition to the global managers, which are setup from the SNMP menu.
Use the following steps to configure the SNMP notification settings:
1. From the Edit menu > Notification screen select an ID number to use, refer to Figure 2.16.
Note: Pager IDs are used in the alarm provisioning screen to designate the primary and secondary
person/device being paged when an alarm condition occurs or clears.
2. Under the Type column, select SNMPv1 from the drop-down menu, see Figure 2.16.
3. Set the SNMP port under the PIN/Rcpt/Port heading, usually 162.
4. Enter the IP address of the SNMP manager in the IPA field.
2.6.7

SNMPv3 Notification Setup

The SNMPv3 notification feature allows you to view alarm status from multiple SNMP managers in
addition to the global managers, which are setup from the SNMP menu.
Use the following steps to configure the SNMP notification settings:
1. From the Edit menu > Notification screen select an ID number to use, refer to Figure 2.16.
Note: Pager IDs are used in the alarm provisioning screen to designate the primary and secondary
person/device being paged when an alarm condition occurs or clears.
2. Under the Type column, select SNMPv3 from the drop-down menu, see Figure 2.16.
3. Enter a v3-User ID under the v3-User heading. The values can range from 0-4. These values refer to
the v3-Users table in the SNMP page. The v3-User association is used to specify username,
security mode, and passwords that should be used for sending a v3-Trap.
4. Set the SNMP port under the PIN/Rcpt/Port heading, usually 162.
5.. Enter the IP address of the SNMP manager in the IPA field.