External Clock Source - Atmel ATtiny25 Manual

13.2

External Clock Source

7598H–AVR–07/09
An external clock source applied to the T0 pin can be used as Timer/Counter clock (clk
T0 pin is sampled once every system clock cycle by the pin synchronization logic. The synchro-
nized (sampled) signal is then passed through the edge detector.
equivalent block diagram of the T0 synchronization and edge detector logic. The registers are
clocked at the positive edge of the internal system clock (
high period of the internal system clock.
The edge detector generates one clk
= 6) edge it detects.
Figure 13-1. T0 Pin Sampling
D Q
Tn
LE
clk
I/O
The synchronization and edge detector logic introduces a delay of 2.5 to 3.5 system clock cycles
from an edge has been applied to the T0 pin to the counter is updated.
Enabling and disabling of the clock input must be done when T0 has been stable for at least one
system clock cycle, otherwise it is a risk that a false Timer/Counter clock pulse is generated.
Each half period of the external clock applied must be longer than one system clock cycle to
ensure correct sampling. The external clock must be guaranteed to have less than half the sys-
tem clock frequency (f
ExtClk
sampling, the maximum frequency of an external clock it can detect is half the sampling fre-
quency (Nyquist sampling theorem). However, due to variation of the system clock frequency
and duty cycle caused by Oscillator source (crystal, resonator, and capacitors) tolerances, it is
recommended that maximum frequency of an external clock source is less than f
An external clock source can not be prescaled.
pulse for each positive (CSn2:0 = 7) or negative (CSn2:0
T 0
D Q
Synchronization
< f /2) given a 50/50% duty cycle. Since the edge detector uses
clk_I/O
ATtiny25/45/85
Figure 13-1 shows a functional
). The latch is transparent in the
clk
I/O
D Q
Edge Detector
clk_I/O
). The
T0
Tn_sync
(To Clock
Select Logic)
/2.5.
79