Checking Tire; Every 50 Hours Or 1500 Km; Checking Engine Start System; Greasing - Kubota SIDEKICK RTV-XG850 Operator's Manual

DAILY CHECK
Cargo load
condition
0 to less than
550 lbs. (0 to 25 x 10 - 12
less than HDWS ATV
250 kg)
550 lbs or more 25 x 10 - 12
(250 kg or more) HDWS ATV
(1) Ground
(A) "INSUFFICIENT"

17. Checking tire

1. Check to see if tires are not damaged.
2. If the tires are cracked, bulged, or cut, or they are
worn out, replace or repair them at once.
Tire tread depth
Always replace the tires when the tread depth is
worn to minimum allowable(A).
(A) Minimum allowable tread depth 5 mm (0.2 in.)
RTV-XG850
Inflation pres-
Tire
sure
120 kPa
Front 1.2 kgf/cm
17 psi
120 kPa
Rear 1.2 kgf/cm
17 psi
120 kPa
Front 1.2 kgf/cm
17 psi
170 kPa
Rear 1.7 kgf/cm
24 psi
(B) "NORMAL"
(C) "EXCESSIVE"

EVERY 50 HOURS OR 1500 KM

Be sure to do the following servicing once every 50
hours or 1500 km, whichever comes first.
2

1. Checking engine start system

2
WARNING
To avoid serious injury or death:
2
• Do not allow anyone near the vehicle while
testing.
• If the vehicle does not pass the test, do not
2
operate the vehicle.
Preparation before testing.
1. Place all control levers in the "NEUTRAL" position.
2. Set the parking brake and stop the engine.
Test: Range gear shift lever safety switch
1. Sit on the operator's seat.
2. Shift the range gear shift lever to [H] position.
3. Return the speed control pedal to the "NEUTRAL"
position.
4. Turn the key to "START" position.
5. The engine must not crank.
6. Repeat the step 2 to 5 with the range gear shift
lever at [L] and [R] each position.
7. If it cranks, consult your local KUBOTA Dealer for
service.
(1) Range gear shift lever

2. Greasing

Apply a small amount of multi-purpose grease to the
following points every 50 hours: If you operate the
vehicle in extremely wet and muddy conditions,
lubricate grease fittings daily.
PERIODIC SERVICE
(2) Speed control pedal
63