Input Crop - NovaStar NovaPro UHD User Manual

− H: Set the layer height.
Note:
Click next to the width and height to lock the layer aspect ratio. The icon changes to
is locked. If you change the layer width or height at this time, the other parameter changes accordingly based
on the locked aspect ratio.

7.3.2.2 Input Crop

If you want to view a certain area of the input source image, crop the input source image and make the
desired part display in full screen.
Select Input Crop to turn on the function. If no signal is detected, the function is unavailable.
Figure 7-13 Input crop

X: Set the horizontal initial position for the input source cropping. The value ranges from 0 to the horizontal
width of the input source, and defaults to 0.

Y: Set the vertical initial position for the input source cropping. The value ranges from 0 to the vertical
height of the input source, and defaults to 0.

W: The horizontal width of the current input source. If no signal is detected, it defaults to 1920.

H: The vertical height of the current input source. If no signal is detected, it defaults to 1080.
The effect is shown as follows after the cropping.
Figure 7-14 Input crop effect
Input Source: 1920×1080@60Hz
www.novastar.tech
NovaPro UHD All-in-One Controller User Manual
when the ratio
Layer Size: 1920×1080
66