Layer Settings; Layer; Layer Properties - NovaStar NovaPro UHD User Manual

Load RCFGx Files
After the LED screen is powered on, if a certain cabinet or the entire LED screen is not lit, you can save the
receiving card configuration files (*.rcfgx) that have been configured on NovaLCT software to the USB drive,
and then load the files from the USB drive.
Figure 5-6 Loading RCFGx files
Note:
The NovaPro UHD does not support importing the configuration files by directly connecting to NovaLCT.
LED Screen Color
Adjust the color temperature and Gamma value of LED screen to make the images displayed on the screen
more clear and vivid.

Color Temperature: Adjust the cool or warm degree of images displayed on LED screen.

Gamma: Adjust the image distortion degree from the input to output. The greater the value is, the more
distorted the image will be. The value ranges from 0.25 to 4.00.

5.4 Layer Settings

5.4.1 Layer

5.4.1.1 Layer Properties

Figure 5-7 Layer properties
Menu
Select Layer
Status
Input Source
Layer Adjust
www.novastar.tech
Description
Select the desired layer. At most 6 layers are supported.
Note:
Press a number button in the LAYER area on the device front panel to enter the layer
settings screen and open the selected layer.
Open or close the layer.
Select the input source for the selected layer.
Note:
Press an input source button in the SOURCE area on the device front panel to quickly
select an input source for the layer.
Adjust the aspect ratio, size and other parameters of the layer.
 Aspect Ratio: Set the proportional relationship between the layer's width and height.
NovaPro UHD All-in-One Controller User Manual
11