Displaying The Zero Offset "Overview - Siemens SINUMERIK 840D SL Operating Manual

Note
Further details on zero offsets
If you would like to see further details about the specified offsets or if you would like to
change values for the rotation, scaling or mirroring, press the "Details" softkey.
2.7.2

Displaying the zero offset "overview"

The active offsets or system offsets are displayed for all set-up axes in the "Zero Offset -
Overview" window.
In addition to the offset (course and fine), the rotation, scaling and mirroring defined using
this are also displayed.
This window is generally used only for monitoring.
Display of active zero offsets
Zero offsets
DRF
Basic reference
External ZO frame
Total base ZO
G500
Tool reference
Workpiece reference
Programmed ZO
Cycle reference
Total ZO
Milling
Operating Manual, 02/2012, 6FC5398-7CP40-3BA0
2. Press the "Zero offset" softkey.
The "Zero Offset - Active" window is opened.
Displays the handwheel axis offset.
Displays the additional zero offsets programmed with $P_SETFRAME.
Access to the system offsets is protected via a keyswitch.
Displays the additional zero offsets programmed with $P_EXTFRAME.
Displays all effective basis offsets.
Displays the zero offsets activated with G54 - G599.
Under certain circumstances, you can change the data using "Set ZO",
i.e. you can correct a zero point that has been set.
Displays the additional zero offsets programmed with
$P_TOOLFRAME.
Displays the additional zero offsets programmed with $P_WPFRAME.
Displays the additional zero offsets programmed with $P_PFRAME.
Displays the additional zero offsets programmed with $P_CYCFRAME.
Displays the active zero offset, resulting from the total of all zero
offsets.
Setting up the machine
2.7 Zero offsets
113