Siemens SINUMERIK 840D Description Of Functions page 6

Foreword
•
•
•
•
•
User-oriented activities such as the creation of parts programs and control
operating procedures are described in detail in separate documents.
Separate descriptions are likewise provided for the tasks to be performed by
the tool manufacturer such as configuring, installation and PLC programming.
Notes on how to use The following reference guides are provided in this Description of Functions:
this manual
•
•
•
•
If you need information about a certain term, please look in the Appendix of the
Chapter Index for the particular term. Both the chapter number and the page
number where you will find the information you need are listed in this chapter.
Documentation with
Edition date 08.97
The following functions added since 04.96 Edition are described in 08.97
Edition for SINUMERIK 840D/611 digital
Table 0-1
Serial no.
1
2
3
4
5
6
7
8
9
10
11
12
13
Notes:
1)
Documentation with
Edition date 04.99
vi
SINUMERIK 840D/SIMODRIVE 611 digital SINUMERIK Safety Integrated (FBSI) - Edition 11.03
Description of safety functions
Lists and description of all signals and data
Start-up
Description of alarms
One example configuration.
Overall table of contents
Table of contents for each chapter
Appendix with list of abbreviations and references
Index
Note
Documentation with Edition date 08.97 describes the scope of functions of the
following products and SW versions:
SINUMERIK 840D/611 digital with software version 4.2
SINUMERIK 840C/611 digital with software version 6.1
New functions described in 08.97 Edition
New functions in SINUMERIK 840D/611 digital, SW 4.2 and higher
Override for safely reduced velocity
Safe braking ramp
Safe speed oriented stop responses
Safe speed oriented setpoint limits
Safe cams for endlessly turning rotary axes
Modulo display of safe actual value for rotary axes
Synchronization of cam SGAs
SGA "n < n "
x
SGA "SBH active"
SGA "SG active"
Deletion of zero speed position for SBH/SG axes
Encoder limit frequency 300 kHz
Acceptance report (not a function)
available from SW 3.6
Note
1)
1)
© Siemens AG 2003 All Rights Reserved
11.03