Siemens SINUMERIK 840D Description Of Functions page 356

6 Alarms
6.3 Alarm suppression
27104
27105
27106
27107
27124
27200
27201
27202
27203
27204
27205
27206
27207
27220
27221
27222
27223
27224
27225
27240
27241
27242
27250
27251
27252
27253
27254
27255
27256
27299
-
-
-
-
-
-
-
-
-
-
Reasons for not suppressing alarms:
•
•
•
•
•
6-356
SINUMERIK 840D/SIMODRIVE 611 digital SINUMERIK Safety Integrated (FBSI) - Edition 11.03
- no
- no
- no
- no
- no
- no
- no
- no
- no
- no
- no
- no
- no
- no
- no
- no
- no
- no
- no
- no
- no
- no
- no
- no
- no
- no
- no
- no
- no
- no
300500 no
300745 no
300746 no
300747 no
300748 no
300749 no
300776 no
301706 no
301707 no
301708 no
27001-300911: The information content of the NCK alarm is more
extensive than that of the drive alarm and must continue to appear in the
alarm log so that this information is accessible to service personnel.
27002-300951: These alarms continue to be displayed separately because
under normal conditions they are never triggered by both channels
simultaneously and because simultaneous occurrence of these alarms
causes problems in the test stop interface.
27031-301701: Parameterization alarm - is no longer triggered on the
NCK side.
27032-300744: Checksum errors in the parameterization of the safety
MD are initiated once at power on and then usually do not re-occur. If
these alarms do occur, this indicates a problem in the MD parameterization
which can be separately changed for both monitoring channels.
27003: OEM monitoring functions are only implemented in the NCK.
© Siemens AG 2003 All Rights Reserved
11.03