Siemens SINUMERIK 840D Description Of Functions page 301

11.03
000193 0 0 "Anwendertext $A_OUTSI(P)[01]"
000256 0 0 "Anwendertext $A_OUTSI(P)[64]"
000257 0 0 "Anwendertext $A_OUTSI(P)[01]"
000320 0 0 "Anwendertext $A_OUTSI(P)[64]"
The assigned user text is then displayed when Alarms 27090 or 27254 occur,
referred to the associated SPL variable.
5.5.3 Servo trace bit graphics for Safety Integrated
General The servo trace function is one of the measuring functions in the start-up area.
Using the servo trace, for drive signals and NCK signals, measurements can be
started by entering a measuring time and trigger conditions. The results of the
measurements are then graphically displayed. Two curves can be displayed in
2 graphics. The results of the measurements can be saved in files. Further, the
graphics can be saved as bitmap file in the HMI_ADV data manager – or
directly printed out.
Starting servo trace After MMCWIN has been started, the start-up operator area can be reached
using the horizontal "Start-up" softkey (also refer to Section 5.3).
After this softkey has been pressed, one menu level lower can be accessed
and the servo trace reached by pressing the horizontal "drives/servo" softkey.
The basic servo trace display appears after pressing the horizontal servo trace
softkey:
© Siemens AG 2003 All Rights Reserved
SINUMERIK 840D/SIMODRIVE 611 digital SINUMERIK Safety Integrated (FBSI) - Edition 11.03
5 Commissioning
5.5 Diagnostics
5-301