Configuring With Com Profibus; Harmonizing With Data Configured In Cfc - Siemens SIMADYN D Manual

Communications configuring
3.5.2

Configuring with COM PROFIBUS

General
3.5.2.1

Harmonizing with data configured in CFC

Rules
3-58
Bit 7, 8 of the header byte
Bit 7, 8= 00
Bit 7, 8= 01
Bit 7, 8= 10
Table 3-27 Significance of bit 7 and bit 8 of the header byte
Bits 1 to 6 define the following:
• For device- and identification-related diagnostics the length of the
diagnostic block including the header byte, value range 2...63.
• For channel-related diagnostics, the identification number, value
range 0...63.
Output of additional slave diagnostics data
• Diagnostic bytes 17 to 32 of a slave are output with SEL=1002 to
SEL=1123.
COM PROFIBUS (Windows) should be used when configuring (it is also
possible to use the earlier COM ET200 Version 2.1 for configuring).
Using COM PROFIBUS you can define:
• The number and configuration of the nodes connected to the
PROFIBUS DP bus system
• The baud rate
• Important parameters when using the PROFIBUS DP bus system
SIMADYN D-specific information on COM PROFIBUS:
• Configure the SS52 communications module as SIMADYN D SS52
station type ("SIMADYN" family).
• The input and output addresses should not be specified.
• After completing the configuring, the database is downloaded into
SS52 via the DP bus using the menu command File > Export > DP
master.
• Alternatively, it is also possible to download via RS232. The following
menu command is used to start loading the SS52: File > Export >
SIMADYN Master.
The configured software should be harmonized with one another as
follows:
Device-related diagnostics
Identification-related diagnostics
Channel-related diagnostics
System- and communication configuring D7-SYS - SIMADYN D
Significance
Edition 12.2003