Configuring Wincc; Binary Events; Simadyn D Messages; Simadyn D Configuring Software - Siemens SIMADYN D Manual

Communications configuring
3.29.2.2

Configuring WinCC

3.29.3

Binary events

Simadyn D
configuring
software
WinCC configuring
software
3.29.4

SIMADYN D messages

3.29.4.1

SIMADYN D configuring software

FB MM
I/O name
CTS
AR
NZ
NL
MEM
TGL
3-310
For the particular example, it is sufficient to use a basic WinCC
configuring software with several input/output fields.
We will not discuss the WinCC configuring software here. If you require
further information refer to the comprehensive WinCC Configuring
Manuals. We recommend the Getting Started SIMATIC WinCC Manual
for an introduction into configuring WinCC.
No additional configuring is required for process value visualization for
the binary event technique with WinCC. The selection regarding which bit
of a variable initiates which message is realized exclusively in WinCC.
The configuring rules to output process variables remain.
In addition to configuring software for the process variables, an ALARM
logging configuring software must be generated. We will not discuss the
WinCC configuring software here. If you require more detailed
information, refer to the comprehensive WinCC Configuring Manuals. We
recommend the Getting Started SIMATIC WinCC Manual for an
introduction into configuring WinCC.
To output messages from SIMADYN D to WinCC, the WinCC block MM
is required in addition to configuring the process value output :
• MM message manager
The blocks are connected as follows :
(Only the relevant connections are described)
Significance
Processor name
Channel name
(This is identical with the AT connection of the MSI
block)
No. of cycles per data transfer
No. of connected LI blocks
Diagnostics triplet
Diagnostics triplet
System- and communication configuring D7-SYS - SIMADYN D
Example
D01_P1
EMPFKANA
5
1
0
0
Edition 12.2003