Siemens SIMADYN D Manual page 385

Communications configuring
Configuring
software
CFC chart
3.27.2.2.3 Writing function block connections
Brief description
NOTE
Configured
software
3-296
FB Connection
BF T
CTR LU
Y
Table 3-96 Connection assignment, BF and CTR
Fig. 3-120 Reading function block connections
A value from OP7 is read-in using a global operand (OP connection), fed
through a dummy block (NOP1_I), and is sent back to the OP7 with an
additional global operand (OP connection); it is read-out from the OP7.
The flag No. for the OP connections, specified under SIMADYN D,
must also be assigned the configured variables under ProTool/Lite.
FB Connection
NOP1_I X
Y
Table 3-97 Connection assignment, NOP1_I
Connection assignment (significance)
500ms (time constant)
50 (counter upper limit)
Symbol name: Z_output
Flag No.: MW10
(global operand, OP connection)
Connection assignment (significance)
Symbol name: OP_SOLL
Flag No.: MW20
(global operand, OP connection)
Symbol name: OP_IST
Flag No.: MW30
(global operand, OP connection)
System- and communication configuring D7-SYS - SIMADYN D
Edition 12.2003