Siemens SIMADYN D Manual page 464

Closed-loop thyristor current control
SOL. Significance
ZST Diag.: Stop in the status of the specified number (ZVA)
(The pre-set value (Default value) can only be modified by
trained personnel!)
TA Processing time, switch-over logic stage
QON Closed-loop current control operational
(only enabled if there are no faults and after a switch-on
command and setpoints WC1+WC2 > WCL > 0.0)
QPL Pulse inhibit
(the status is displayed at connector ITDC-X5:15 = 0)
QPS Shift to inverter operation is executed
(The firing angle PC6.AWS becomes active.)
QCE Enables the current controller
QCS Sets the current controller FB-CPI, set or track
Q01 Torque direction M1 operational
(setpoint is switched-through to YWC)
Q02 Torque direction M2 operational
(setpoint is switched-through to YWC)
QSE Test mode is switched-in
QM0 M0 requested, current setpoint < WCL
= neither M1 nor M2 requested
QM1 M1 requested
QM2
M2 requested
QCC
Control word for FB-PC6
YWC Current setpoint
YSV Setting value, current controller even when tracking is switched-
in
ZVL Diag.:(n-1) status
ZVA Diag.:(n) status , control state machine
ZVN Diag.:(n+1) status
ZIA Diag.:Status, interrupt state machine
YHW Signaling word hardware ITDC
(masked by HMH)
YW1 Alarm word 1
YW2 Alarm word 2
QW Sum, alarm
1 bit in YW1 or YW2 = 1
YF1 Fault word 1
YF2 Fault word 2
QF Sum, fault signal
1 bit in YF1 or YF2 = 1
Table 5-3 I/O SOL
5-24
(masked using HM1)
(masked using HM2)
System- and communication configuring D7-SYS - SIMADYN D
Value\connection
(Default: 100 )
(Default: 0 ms)
(Default: 0)
(Default: 0)
(Default: 0)
SOL.QCE → CSP.EN
(Default: 0)
SOL.QCS → CPI.S
SOL.QCS → CSP.EN
(Default: 0)
SOL.Q01 → CAV.IM1
(Default: 0)
SOL.Q02 → CAV.IM2
(Default: 0)
(Default: 0)
(Default: 0)
(Default: 0)
(Default: 0)
SOL.QCC → PC6.ICC
(Default: 16#0000)
SOL.YWC → CSP.WC
(Default: 0.0)
SOL.YSV → CPI.SV (Default:
0.0)
(Default: 0)
(Default: 0)
(Default: 0)
(Default: 0)
(Default: 16#0000)
(Default: 16#0000)
(Default: 16#0000)
(Default: 0)
(Default: 16#0000)
(Default: 16#0000)
(Default: 0)
Edition 06.2002