Operation With General Dp Master; Bus Run-Up - Festo CP-FB13-E Programming And Diagnostics Manual

2. Commissioning
2.3

Operation with general DP master

2.3.1 Bus run-up

2-36
The Festo CP system can be controlled from any PLC, PC or
industrial PC with a PROFIBUS-DP module in accordance with
EN 50170 (DIN 19245).
Information on the functions FREEZE, SYNC, the DP ident-
ifiers, standard and compact mode can be found in section
2.1.4.
Before the CP system can be commissioned properly, the DP
master must perform the following functions in the sequence
specified.
1. Send parametrizing data
2. Send configuration data
3. Request diagnostic information
4. Start cyclic data transmission
The structure and contents of the individual telegrams are
described in the following chapters.
Festo P.BE-CP-FB13-E-EN en 0112e