Festo CP-FB13-E Programming And Diagnostics Manual page 59

2. Commissioning
Fig. 2/16: Configuration with STEP7 Hardware Catalog
Festo P.BE-CP-FB13-E-EN en 0112e
3. With the mouse key pressed down pull the marked sta-
tion type onto the PROFIBUS line on the DP master 3
(drag & drop).
The mask "Properties - PROFIBUS node" will appear.
4. Select the PROFIBUS address identical to the selected
setting on the rotary switch/DIL switch (see chapter 1.2.1)
in the slave and confirm with OK 4.
The icon of the valve terminal appears in the PROFIBUS
line 5.
Configuration in standard mode with STEP7 V5.1
1. Mark the icon of the valve terminal to be configured in the
HW Config 5 in Fig. 2/15).
2. Mark the highest assigned string in the Hardware Catalog
and pull it with the mouse key pressed down onto line 0
in the configuration table (see Fig. 2/16).
The program automatically enters the identifiers in this
mask in standard mode.
2-27