Festo CP-FB13-E Programming And Diagnostics Manual page 60

2. Commissioning
Fig. 2/17: Configuration with STEP7 Hardware Catalog
2-28
Configuration in compact mode with STEP7 V5.1
2
If you wish to use the compact mode, proceed as follows:
1. Mark the icon of the valve terminal to be configured in the
HW Config 5 in Fig. 2/15).
2. Mark the universal module 1 in the Hardware Catalog
and pull it with the mouse key pressed down onto line 0
in the configuration table.
3. Open the mask "Properties DP slave" 2 by double click-
ing the appropriate line in the configuration table.
4. Repeat steps 2 and 3 if necessary for a second identifier.
1
Festo P.BE-CP-FB13-E-EN en 0112e