Festo CP-FB13-E Programming And Diagnostics Manual page 39

2. Commissioning
Festo P.BE-CP-FB13-E-EN en 0112e
Sequence of the configuration entries
Caution
The number of inputs/outputs must correspond to the
equiment fitted on the CP system. The configuring of addi-
tional inputs and outputs as a later reserve is not per-
mitted.
DP identifier
Please note
DP identifier 049 resp. 16DX (standard mode) has been
used for the examples.
The configuration data must be known or ascertained for
each bus slave. There are two methods of configuring the CP
system:
– Standard mode
– Compact mode.
On the basis of the DP identifier sent by the master, the CP
system automatically recognizes the mode in which you wish
to operate the CP system.
Caution
Configure a CP system only in one of the following ways:
– standard mode (max. 4 x 049)
– compact mode (sum identifiers).
Mixing the two identifiers is not permitted.
2-7