Festo CP-FB13-E Programming And Diagnostics Manual page 49

2. Commissioning
Configuring
Festo P.BE-CP-FB13-E-EN en 0112e
Configuration with COM PROFIBUS 3.x
Prerequirements:
– The device master file must be in the directory of your
PC/programmer.
– The mask "Bus parameter" must be edited (bus profile,
baud rate).
– The PROFIBUS address must be assigned (see above).
– The station type "FESTO CP FB13" must be selected
(see above).
Access the mask "Configure"
1. Double-click with the left-hand mouse key or once with
the right-hand key on the icon of the Festo valve terminal.
2. Now click "Configure" in the menu which appears.
The mask "Configure" will appear (Fig. 2/8).
2-17