05.91
F
F2
F
SET
F1
F
ACTUAL
F3
Continuous path operation G64
Note:
If, on a transition from continuous path control to exact stop, the path of the transition block is
shorter than the required deceleration distance, the velocity is immediately reduced to zero by
function G09.
Alarm 3092 "Programmed speed too high" is displayed.
The fine and coarse exact stop tolerance ranges can be
4.2.7.2 Continuous path operation G62/G64
The preparatory function G64 is used if no relief cutting is to occur at transitions from block to
block. This function also causes transitions to be smoothed when changing the direction of
movement. When applying a dry run feedrate with G64, the dry run feedrate is used both
during the block and at the end of the block. The programmed feedrate value is not used.
F
F2
F
SET
F1
F
ACT
F3
Continuous path operation G64
© Siemens AG 1991 All Rights Reserved
SINUMERIK 880, (PG)
4.2.7 Exact positioning G09/G60, G00, continuous path operation G62/G64
Block limits
modified with machine data.
Block limits
6ZB5 410-0HD02
4 Programming of Motion Blocks
t
t
4–27