Tool Offsets For Angle Cutter; Compensation (Tnrc) - Siemens SINUMERIK 880 Programming Manual

05.91
9.8

Tool offsets for angle cutter

As opposed to the end mill, an angle cutter requires an additional length compensation located
in the plane of the cutter radius compensation. Free axis selection must always be used with
preparatory function G16.
Function G16 is followed in this instance by four axis addresses:
1st and 2nd axis address:
3rd axis address:
4th axis address:
The third and fourth axis addresses can be given a negative sign to reverse the direction of
compensation.
The number "30" must be entered under P1 (tool type).
P1 : Tool type (enter:30)
P2 : Geometry, length 1
P3 : Geometry, length 2
P4 : Geometry, cutter radius
P5 : Wear, length 1
P6 : Wear, length 2
P7 : Wear, cutter radius
Compensation
assignments: G16 X Y Z X
© Siemens AG 1991 All Rights Reserved
SINUMERIK 880, (PG)
Plane in which the cutter radius compensation is to be active
Standard length compensation as in the case of the end mill
Additional length compensation in the cutter radius plane.
X
Length 2
Length 1
Radius
Geometry length 2 (additional length compensation)
Geometry length 1 (standard length compensation
as in the case of end mill)
Plane, in which the cutter radius compensation is to
be active
6ZB5 410-0HD02
9 Tool Offsets
9.8 Tool offsets for angle cutter
Z
9–13