Siemens SINUMERIK 880 Programming Manual page 41

05.91
Application example with G59:
The contour has been programmed using absolute position data only. In order to obtain a
finishing allowance, the total contour can be offset in the X coordinate by means of a program-
mable zero offset.
+X
Zero offset with G59
Select: N . . G59 Xa L F
L F
Cancel: N . . G59 X0
The programmable zero offset values set in this program are automatically deleted each time
the program is terminated with M02 or M30 or program abort. All programmable ZOs are
deleted with RESET.
© Siemens AG 1991 All Rights Reserved
SINUMERIK 880, (PG)
a
6ZB5 410-0HD02
3 Directons of Movement, Dimensioning
3.5 Zero offset G54...G59
+Z
3–11