Siemens SINUMERIK 880 Programming Manual page 243

11 Programming of Cycles
11.11 Part program handling
@f12 Copy "X" to program "Y"
This @ code copies a block specified by its block number from a source part program
to the end of a target part program. The target part program must have been
generated before by using @f02, i.e. @f12 is not able to create a new program.
Syntax:
Input parameters:
Output parameters:
CL 800 reserved word:
11–56
@f12 <R > <R >
x y
R : Program type of source program
x
(%=1, L=2, cycle = 3)
R +1: Source program number
x
R +2: Block number in source program
x
R +3: Program type of target program
x
(%=1, L=2, cycle = 3)
R +4: Target program number
x
R +5: Block number in target program
x
R : Error feedback
y
0: No error
1: Block not available
2: Target program in EPROM or write-
protected
3: Parity error
4: Memory full
5: Target program not available
6: Source program not available
COPY BLOCK
© Siemens AG 1991 All Rights Reserved
05.91
6ZB5 410-0HD02
SINUMERIK 880, (PG)