Siemens SINUMERIK 880 Programming Manual page 242

05.91
@f11 Read block out of program, according to block number
This @ code reads a block specified by its block number from a particular part
program into a machining buffer. This buffer is cleared each time @f11 is executed
causing an old block that might still exist to be overwritten.
As in the case of @f10 it is also necessary to first select a part program via @f01.
Syntax:
Input parameters:
Output parameters:
CL 800 reserved word:
© Siemens AG 1991 All Rights Reserved
SINUMERIK 880, (PG)
@f11 <R > <R >
x y
R : Program type (%=1, L=2)
x
R +1: Program number
x
R +2: Block number
x
R : Error feedback
y
0: No error
1: Block not available
2: Program not available
3: Parity error
4: No block start
5: Invalid address
6: Error in comparison
7: No LF
R +1: Sector number of next block
y
R +2: Offset of next block
y
R +3: Number of characters in block
y
READ BLN
6ZB5 410-0HD02
11 Programming of Cycles
11.11 Part program handling
11–55