Siemens SINUMERIK 880 Programming Manual page 214

01.93
Main group 4/subgroup 0: Transfer R parameter in machine data
@400 <Value 1> <Value>
The address of an NC machine data is defined in <Value 1> .
Address area: 0 to 4999.
Example:
@400 K2241 R90
@401 <Value 1> <Value>
The byte address of an NC machine data bit is defined in <Value 1>.
Address area: 5000 to 18240.
@402 <Value 1> <Value 2> <Value>
The byte address of an NC machine data bit is defined in <Value 1>.
Address area: 5000 to 18240. The bit address (0 to 7) is given in <Value 2>.
@403 <Value 1> <Value 2> <Value>
The address of a cycle machine data is defined in <Value 2>.
Where:
<Value 1> Channel no.; when simulating a program, only a cycle machine data from
the channel in which the program is running (no. 0) can be described.
<Value 2> Word address
@404 <Value 1> <Value 2> <Value>
The byte address of a cycle machine data is defined in <Value 2>.
Where:
<Value 1> Channel no.; when simulating a program, only a cycle machine data from
the channel in which the program is running (no. 0) can be described.
<Value 2> Byte address
@405 <Value 1> <Value 2> <Value 3> <Value>
The bit address of a cycle machine data is defined in <Value 3>.
Where:
<Value 1> Channel no.; when simulating a program, only a cycle machine data from
the channel in which the program is running (no. 0) can be described.
<Value 2> Byte address
<Value 3> Bit address
@406 <Value 1> <Value>
The address of a PLC machine data is defined in <Value 1>.
Address area: 0 to 5999.
@407 <Value 1> <Value>
The byte address of a PLC machine data is defined in <Value 1>.
Address area: 6000 to 8999.
@408 <Value 1> <Value 2> <Value>
The byte address of a PLC machine data bit is defined in <Value 1>.
Address area: 6000 to 8999. The bit address (0 to 7) is given in <Value 2>.
© Siemens AG 1991 All Rights Reserved
SINUMERIK 880, (PG)
11.7 Data transfer: R parameter into system memory
The machine data of the first software limit switch for the
second axis in the plus direction is loaded via parameter
R90.
6ZB5 410-0HD02
11 Programming of Cycles
11–27