Siemens SINUMERIK 880 Programming Manual page 25

2 Fundamentals of Programming
2.7 Input/output formats
%
L F
TOG 17...18
T1 P0=...P11=...LF
T2 P0=...P11=...LF
L F
M02
Memory areas
The memory areas of the SINUMERIK 880 control are addressed by means of the following
identifiers:
Identifier
MPF Part program (Main Program File)
SPF Subroutine (Sub Program File)
PCF PLC error message text (PLC Files)
TOA Tool offsets (Tool Offset Active)
ZOA Zero offsets
(Zero Offset Active)
TEA1 NC machine data (Testing Data Active 1)
TEA2 PLC machine data (Testing Data Active 2)
TEA3 IAR machine data (Testing Data Active 3)
TEA4 Cycle machine data (Testing Data Active 4)
RPA R parameter numbers with value assignments
( R Parameter Active)
SEA Addresses with value assignments
(Setting Data Active)
SEA4 Cycle setting data (Setting Data Active 4)
CLF Clear statement (Clear File)
UMS User memory submodule
TOG Simulation tool data (Tool Offset Graphics)
Deleting programs
These functions permit part programs and subroutines to be deleted in any sequence via the
input/output interface.
DELETE PROGRAM
L F
%CLF
MPF 1234 L F
L F
MPF 1, 1200
MPF 0, 9999 L F
L F
SPF 10
SPF 11, 79 L F
L F
SPF 1, 999
PCF 1, 9999
L F
M30, M02 or M17
2–14
Simulation tool offset (TOOL OFFSET GRAPHICS)
Simulation tool data
Simulation tool data - End of data block
Leader
Delete program identifier (CLEAR FILE)
Delete part program % 1234
Delete part program %1 to % 1200
Delete all part programs
Delete subroutine L10
Delete subroutines L11 to L79
Delete all subroutines (except cycles)
PLC error message
End identifier M30, M02 or M17
© Siemens AG 1991 All Rights Reserved
05.91
6ZB5 410-0HD02
SINUMERIK 880, (PG)