Rexroth Indramat ECODRIVE03 Series Project Planning Manual page 83

ECODRIVE03 Drive Controllers
Installation notes for RS485
ECODRIVE03 DKC**.040, DKC**.100, DKC**.200
RS485 interface
The RS485 interface is used for programming, parameterization and
diagnoses at start up and service.
It makes possible:
• the implementation of a serial bus with up to 31 participants connected
via a two-wire cable (half duplex mode)
• A transmission length of up to 500 m
• Transmission rates of 9600/19200 baud
• The use of a centrally PC supported visualization unit
Using an RS485 enables the commissioning of several DKCs with
DriveTop without changing the interface cables is possible.
The following options for working with RS485 are available
• RS232/RS485 converter between PC and drives
• RS485 plug-in card in PC
Please contact your PC supplier to help nd solutions.
–
cables
Note: Details are listed in "Electromagnetic compatibility (EMC) and
control systems", doc. Type DOK-GENERL-EMV********-PRxx.
customerservice@hyperdynesystems.com
4-51
| (479) 422-0390