Replacing The Firmware Module; Replacing The Programming Module (Complete Module) - Rexroth Indramat ECODRIVE03 Series Project Planning Manual

15-8
Replacing or Exchanging Drive Components

Replacing the Firmware Module

Replacing the Programming Module (complete module)

customerservice@hyperdynesystems.com
• Switch drive controller o
• Loosen screw at programming module and pull programming module
out
• Pull programming module out
• Open the lock on the back of the programming module
• Open the programming module
• Insert old parameter module into new rmware module
• Close lock (lock must be pushed outward)
• Insert programming module and screw on
• Switch drive controller on
• Secure parameters (DriveTop)
• Switch drive controller o
• Loosen screw at programming module and pull programming module
out
• Insert new programming module
• Switch drive controller on
• Load parameters (DriveTop)
| (479) 422-0390
ECODRIVE03 Drive Controllers