Rexroth Indramat ECODRIVE03 Series Project Planning Manual page 137

ECODRIVE03 Drive Controllers
Data rate, transmitter power
Position of switch
Data rate
ECODRIVE03 DKC**.040, DKC**.100, DKC**.200
Switch S20
The transmitter power and the data rate for the SERCOS interface are set
with the switch S20.
The DKC is factory set to an average transmitter power (-4.5 dBm) and
the lowest data rate(2 Mbit/s).
The switches are in OFF position if the switch lever is facing the rear (rear
panel). Switch S20/1 is down (see marking on the unit).
Distortion LED of the
SERCOS interface
ERROR
H20
3
2
1
Fig. 4-177: Position of the switch for data rate and transmitter power
demonstrating how to switch it ON and OFF
The data rate is set with the switch S20/1.
Position of switch S20/1
O F F
O N
Fig. 4-178: Relationship between switch position S20/1 and the data rate
customerservice@hyperdynesystems.com
OFF
S20
3
Switch for setting the transmitter power
2
1 Switch for setting the data rate
ON
Data rate in Mbit/s
| (479) 422-0390
4-105
FP5031F1.FH7
2
4