Setting The Registration Mark Cutting Function - GRAPHTEC CUTTING PRO FC2250 Series User Manual

Chapter 4 REGISTRATION MARK SETTINGS AND DETECTION

4.13 Setting the Registration Mark Cutting Function

If your registration mark pattern is Mirror 1 or Mirror 2, the registration marks can be cut after they have been
detected.
(1) Select either AXIS or MARKS for the registration mark mode (see Section 4.2, "Setting the Registration Mark
Mode".)
(2) With the plotter in Ready status, press the [ORIGIN] key to display the following menu.
FORCE
1
2
SPEED
(3) Press the [NEXT] key to display the following menu.
FORCE
MIRROR MARKS
START POS
SPEED
(4) Press the [F1] key (MIRROR MARKS) to display the menu for cutting mirror marks.
FORCE
CUT MIRROR MARKS
ON
SPEED
The currently selected setting is indicated by a black dot [
To cut a registration mark, press the [F2] key (ON).
If you do not wish to cut a registration mark, press the [F4] key (OFF).
When the displayed setting is satisfactory, press the [ENTER] key to confirm your selection.
(5) When ON has been selected, a menu for setting the spacing for the selected registration mark mirror pattern is
displayed.
FORCE
MARK TYPE:MIRROR
SPACING = 3.0 mm
SPEED
Use the [ ] or [
Setting range: 0 to 9.9 (mm)
Set value
Set value
(6) After the registration mark has been detected, the following menu is displayed. (See Section 4.12, "Registration Mark
Detection".)
FORCE
CUT MIRROR MARKS?
YES
SPEED
Press the [F2] key (YES) to perform cutting of the detected registration mark.
4-24
OFFSET
3
MANUAL
QUALITY
OFFSET
QUALITY
OFFSET
OFF•
QUALITY
OFFSET
QUALITY
] key to change the numeric value, and then press the [ENTER] key to confirm your selection.
OFFSET
NO
QUALITY
•
].