GRAPHTEC CUTTING PRO FC2250 Series User Manual page 40

(5) Use the [ ] or [ ] key to move the position of the blinking cursor, and the [
Setting range: 0 to 9.99 mm
Mode 2 (Crease two lines)
Spacing
Actual data
(creasing is not performed
at the actual data position)
Setting the Number of Creasing Operations
(6) Press the [F3] key to move the blinking cursor to the position shown in the following screen.
FORCE
MODE2
SPC 1.00mm ST 0.00mm
SPEED
(7) This setting determines how many times creasing should be repeated for each line segment. Use the [
key to select the value.
Setting range: 1 to 9 (times)
Setting the Start and End Positions
(8) Press the [F4] key to move the blinking cursor to the position shown in the following screen.
FORCE
MODE2
SPC 1.00mm ST 0.00mm
SPEED
(9) This setting determines by what margin each end of the creasing line falls short of the corresponding end of the actual
data line. Use the [
the [ENTER] key to confirm your selections.
Setting range: 0 to 9.99 (mm)
CP-001
Specified value
Actual data
(10) When all the displayed values are correct, press the [ENTER] key. To cancel your settings, press the [NEXT] key.
For short-line data such as circle command data, setting a large value for the ST (Start) parameter may result in creasing
not being performed.
Mode 3 (Crease three lines)
Actual data
OFFSET
COUNT1
QUALITY
OFFSET
COUNT1
QUALITY
] or [ ] key to move the blinking cursor, the [
CP-002/003
Medium
Actual data
Spacing
] or [
Medium
Specified value
Chapter 3 PREPARATIONS FOR CUTTING/PLOTTING
] or [ ] key to select the value.
] key to change the numeric value and
] or [ ]
3-13