GRAPHTEC CUTTING PRO FC2250 Series User Manual page 114

GP-GL Command Mode Error Messages
If any of the following error messages are displayed, one of the following reasons is like to be the cause:
(1) The software's output or interface settings have been changed.
g Configure the software for output by this plotter.
g Ensure that the software's interface settings are correctly set.
(2) The plotter's interface settings have been changed.
g Ensure that the plotter's interface settings are correctly set.
Error message
ERROR 1
COMMAND ERROR !
ERROR 4
PARAMETER OVERFLOW
ERROR 5
I/O ERROR !
Cause
The plotter received an unrecognizable
command.
•
The software's output or interface settings
have been changed.
•
The plotter's interface settings have been
changed.
A command containing a numeric parameter
that exceeds that command's permissible
range was received.
•
The software's output or interface settings
have been changed.
•
The plotter's interface settings have
been changed.
An interface-related error occurred during
data transfer.
•
The software's output or interface settings
have been changed.
•
The plotter's interface settings have
been changed.
Chapter 6 TROUBLESHOOTING
Solution
Configure the software for output by this
plotter.
Ensure that the software's interface settings
are correctly set.
Ensure that the plotter's interface settings
are correctly set.
Configure the software for output by this
plotter.
Ensure that the software's interface settings
are correctly set.
Ensure that the plotter's interface settings
are correctly set.
Configure the software for output by this
plotter.
Configure the software for output by this
plotter.
Ensure that the software's interface settings
are correctly set.
Ensure that the plotter's interface settings
are correctly set.
6-5