Setting The Registration Mark Spacing; Setting The Center Registration Mark - GRAPHTEC CUTTING PRO FC2250 Series User Manual

Chapter 4 REGISTRATION MARK SETTINGS AND DETECTION

Setting the Registration Mark Spacing

(1) If registration mark 3, mirror 1 or mirror has been selected, the menu for setting the registration mark pattern spacing
is displayed.
FORCE
MARK TYPE:3
SPACING =
SPEED
Use the [ ] or [
key to confirm your selection.
Setting range: 0 to 9.9 (mm)
Registration mark pattern 3
Set value

Setting the Center Registration Mark

The center registration mark can only be read for registration mark pattern 3, and only when "USER" has been selected
for the registration mark distance adjustment function.
(1) When registration mark pattern 3 has been selected and the [ENTER] key pressed, the menu for setting the center
registration mark is displayed.
FORCE
CENTER
X=----.-mm Y=---.-mm
SPEED
(2) To perform plotting with the center registration mark as the reference point, press the [F1] key (CENTER) to affix the
•
black dot [ ] next to CENTER and display the following menu. If you do not wish to perform plotting with the center
registration mark as the reference point, press the [F1] key once again to remove the black dot [
the [ENTER] key.
FORCE
•CENTER
X=0030.0mm Y=030.0mm
SPEED
To perform plotting with the center registration mark as the reference point, press the [F2], [F3] or [F4] key to
move the blinking cursor to X (X-axis length), W (center registration mark reading position) or Y (Y-axis length)
respectively. Use the [
and the [ENTER] key to confirm your selections.
Setting range: [X/Y] 0 to 999.9 (mm), [W] -99.9 to +99.9 (mm)
X
a
b
(3) Press the [PAUSE] key to cancel PAUSE mode.
4-6
OFFSET
3.0 mm
QUALITY
] key to change the numeric value. When the displayed setting is satisfactory, press the [ENTER]
Registration mark pattern Mirror 1
Set value
Set value
OFFSET
W= --.-mm
QUALITY
OFFSET
W= 00.0mm
QUALITY
] or [ ] key to move the blinking cursor, the [
Vertical line
a
Y
W
Set W in the range in which there are no vertical or horizontal lines.
Registration mark pattern Mirror 2
Set value
Set value
] or [ ] key to change the numeric value
b
W
Horizontal line
Cutout area
•
] and then press