Creaser Settings - GRAPHTEC CUTTING PRO FC2250 Series User Manual

Chapter 3 PREPARATIONS FOR CUTTING/PLOTTING
(6) When the displayed settings are correct, press the [ENTER] key. To cancel your settings, press the [NEXT] key.

Creaser Settings

The creaser settings enable you to specify the creasing mode, the spacing between creases, the number of
creasing operations and the creasing start and end points.
Only straight lines can be creased. Curved-line data cannot be creased.
(1) The following Creaser Settings screen is displayed when "CP-001" was selected as the cutter blade type and the
[ENTER] key pressed.
If "CP-002" was selected, the Thick Mode Settings screen is displayed (when thick mode assignment has been
enabled). In this case, make the required thick mode settings and then press the [ENTER] key.
FORCE
MODE1
SPC -.--mm ST 0.00mm
SPEED
Setting the Creasing Mode
(2) Press the [F2] key to move the blinking cursor to the position shown in the following screen.
FORCE
MODE1
SPC -.--mm ST 0.00mm
SPEED
(3) The number displayed next to "MODE" is the number of the mode that is currently selected. Use the [
key to select your desired mode.
Selectable parameters: MODE 1. MODE 2, MODE 3
Actual Data
Modes 2 and 3 enable thick media to be bent easily.
Setting the Spacing
(4) Press the [F2] key to move the blinking cursor to the position shown in the following screen.
FORCE
MODE2
SPC 1.00mm ST 0.00mm
SPEED
The spacing parameter is only enabled for Modes 2 and 3. The blinking cursor does not move when Mode 1 has
been selected.
3-12
OFFSET
COUNT1
QUALITY
OFFSET
COUNT1
QUALITY
Mode 1 (Crease one line)
Crease lines at the same position
as the actual data.
OFFSET
COUNT1
QUALITY
Mode 2 (Crease two lines)
Actual data
Crease lines at positions on either side
of the actual data. (Creasing is not
performed at the actual data position)
] or [ ]
Mode 3 (Crease three lines)
Actual data
Crease lines at the same position
as and on either side of the actual
data.