Chapter8 Cpu Module Start-Up Procedures - Mitsubishi Melsec-Q Series User Manual

CHAPTER8 CPU MODULE START-UP PROCEDURES

This chapter provide the start-up procedure for the Q Series CPU module on the assumption that programs and
parameters have been created separately.
For the start-up procedures for a redundant system configured with a Redundant CPU, refer to the following.
QnPRHCPU User's Manual (Redundant System)
Module installation
Install any of the following modules required for the system configuration to the
base unit.
Wiring/connection
1) Wire the power supply to the power supply module.
2) Wire external device(s) to intelligent function module(s), special function mod-
3) Install wiring between network modules.
4) Install the battery to the CPU module.
5) Connect the main base unit to an extension base unit and also between exten-
Module initial settings
1) Halt the CPU module.
2) Set up switches of the intelligent function module(s) and/or special function
3) Set up switches of the network module.
System power on
Confirm the following items of the system, and then power on the system.
Connection of the PC in which GX Developer is installed
1) Start up GX Developer on the personal computer.
2) Connect the personal computer in which GX Developer is installed, to the CPU
8 - 1
•Power supply module
•CPU module (Install a memory card if necessary.)
•Intelligent function module and/or special function module
•Network module
•I/O module
ule(s), and/or I/O module(s).
sion base units by extension cables and then set the number of bases to exten-
sion base units.
module(s).
•Wiring of the power supply
•Power supply voltage
•Operating status of the CPU module: Stop status (reset canceled)
module.
Start
(To next page)
Figure 8.1 CPU module start-up procedures
• • • CHAPTER 10
• • • CHAPTER 6,
CHAPTER 7,
CHAPTER 10
• • • CHAPTER 4
• • • CHAPTER 4,
CHAPTER 5,
CHAPTER 10
• • • GX Developer
Operating
Manual