Selecting The Power Supply Module - Mitsubishi Melsec-Q Series User Manual

5.2.2 Selecting the power supply module

The power supply module is selected according to the total of current consumption of the base units, I/O modules,
intelligent function module, special function module, and peripheral devices supplied by its power supply module.
For the internal current consumption of 5 VDC of the base unit, refer to CHAPTER 6.
For the internal current consumption of 5 VDC of the I/O modules, intelligent function module, special function module,
and peripheral devices, refer to the Manuals of their respective modules.
For the devices obtained by a user, see the manual for the respective device.
(1) When the base unit is Q3 B, Q3 DB or Q6 B:
Power supply module
Q61P, Q62P, etc.
Keep the current consumption of the base unit (Q3 B, Q3 DB, Q6 B) below the 5VDC rated output current of
the Q series power supply module.
(a) Precaution on using the extension base unit (Q5 B)
When Q5
through an extension cable.
Pay attention to the following to use Q5
• Select a power supply module of a proper 5VDC rated output current to be installed to the main base unit
so that it will cover the current used by Q5 B.
For example, if current consumption is 3.0A on the main base unit and 1.0A on Q5 B, any of the power
supply modules shown in Table5.15 must be mounted on the main base unit.
5 - 21
Figure 5.1 Modules and peripheral device that are powered
by power supply module
Table5.14 5VD rated output current
5VDC rated output current
6.0A
3.0A
8.5A
B is used, a power of 5VDC is supplied from the power supply module on the main base unit
Base unit Q35B,
Q65B, etc.
Peripheral devices, converter,
CPU module 1
cables, etc. (for connection
Q02(H)CPU,
between CPU module and
Q06HCPU, etc.
PC)
I/O module QX10,
QY10, etc.
Intelligent function module Q64AD,
QJ71LP21-25, etc.
*1: The CPU module is mounted on the main base unit.
Q61P-A1, Q61P-A2, Q61P, Q61P-D, Q63P
B.
Type
Q62P
Q64P, Q64PN