Mitsubishi Melsec-Q Series User Manual page 386

Error
Code Error Contents and Cause
(SD0)
[FILE SET ERROR]
Program memory capacity was exceeded by per-
forming boot operation or automatic write to stan-
dard ROM.
■Collateral information
• Common Information:File name/ Drive name
• Individual Information:Parameter number
■Diagnostic Timing
• At power ON/At reset/
At writing to progurammable controller
[FILE SET ERROR]
Program memory capacity was exceeded by per-
forming boot operation.
■Collateral information
• Common Information:File name/ Drive name
• Individual Information:Parameter number
■Diagnostic Timing
• At power ON/At reset/
At writing to progurammable controller
[FILE SET ERROR]
The file specified by parameters cannot be made.
■Collateral information
• Common Information:File name/ Drive name
2401
• Individual Information:Parameter number
■Diagnostic Timing
• At power ON/At reset/ At writing to proguramma-
ble controller
[FILE SET ERROR]
• Although setting is made to use the device data
storage file, there is no empty capacity required
for creating the device data storage file in the
standard ROM.
• When the latch data backup function (to standard
ROM) is used, there is no empty capacity
required for storing backup data in standard
ROM. (The parameter number "FFFF
played for the error individual information.)
• Standard RAM capacity is insufficient that error
history of the module cannot be stored.
■Collateral information
• Common Information:File name/ Drive name
• Individual Information:Parameter number
■Diagnostic Timing
• At power ON/At reset/ At writing to proguramma-
ble controller
[FILE OPE. ERROR]
• The specified program does not exist in the pro-
gram memory.
This error may occur when the ECALL, EFCALL,
PSTOP, PSCAN, POFF or PLOW instruction is
executed.
2410
• The specified file does not exist.
■Collateral information
• Common Information:File name/ Drive name
• Individual Information:Program error location
■Diagnostic Timing
• When instruction executed
*1 CPU operation can be set in the parameters at error occurrence. (LED indication varies.)
*3 The function version is B or later.
12 - 91
Corrective Action
• Check and correct the parameters (boot setting).
• Delete unnecessary files in the program memory.
• Choose "Clear program memory" for boot in the
parameter so that boot is started after the pro-
gram memory is cleared.
• Read the individual information of the error using
the peripheral device, check to be sure that the
parameter drive name and file name correspond
to the numerical values there (parameter num-
ber), and correct.
• Check the space remaining in the memory card.
" is dis-
H
Secure the empty capacity of the standard ROM.
• Read the individual information of the error using
the peripheral device, check to be sure that the
program corresponds to the numerical values
there (program location), and correct.
Create a file created using parameters, and load
it to the CPU module.
• In case a specified file does not exist, write the
file to a target memory and/or check the file spec-
ified with the instruction again.
LED Status Corresponding
CPU Status CPU
*3
Qn(H)
QnPH
QnPRH
QnU
RUN:
Off
ERR.:
Flicker
QCPU
CPU Status:
Stop
QnU
RUN:
Off/On
ERR.:
Qn(H)
Flicker/On
QnPH
QnPRH
CPU Status:
QnU
Stop/
*1
Continue