Chapter5 Power Supply Module; Specifications - Mitsubishi MELSEC User Manual

5
POWER SUPPLY MODULE

CHAPTER5 POWER SUPPLY MODULE

This section describes the specifications of the power supply modules applicable for the
PLC system and how to select the most suitable module.

5.1 Specifications

Item
Base loading position
Applicable base unit
Input power supply
Input frequency
Input voltage distortion factor
Max. input apparent power
Inrush current
Rated output
5VDC
current
Overcurrent
5VDC
*1
protection
Overvoltage
5VDC
*2
protection
Efficiency
Allowable momentary power
*3
failure period
Dielectric withstand voltage
Insulation resistance
Noise durability
Operation indication
Fuse
Table5.1 shows the specifications of the power supply modules.
Table5.1 Power supply module specifications
QS061P-A1
QS series power supply module loading slot
100 to 120VAC
(85 to 132VAC)
Across inputs/LG and outputs/FG
1780VAC rms/3 cycles (2000 m (6562 ft.))
Across inputs/LG and outputs/FG, across inputs and LG, across outputs and FG 10M
or more by insulation resistance tester
• By noise simulator of 1500Vp-p noise voltage, 1 s noise width and 25 to 60Hz noise
frequency
• Noise voltage IEC61000-4-4, 2kV
LED indication (Normal: On (green), Error: Off)
Performance Specifications
QS034B
+10%
-15%
50/60Hz 5%
Within 5% ( Section 5.2)
125VA
*4
20A within 8ms
6A
6.6A or more
5.5 to 6.5V
70% or more
Within 20ms
Across inputs/LG and outputs/FG
2830VAC rms/3 cycles (2000 m (6562 ft.))
Built-in (Unchangeable by user)
5.1 Specifications
QS061P-A2
+10%
200 to 240VAC
-15%
(170 to 264VAC)
1
2
3
4
5
6
7
8
5
- 1