Force Sensor Installation - Belarus 1822.3 Operator's Manual

1 – screw; 2 – turn shaft; 3 – cam; 4 – cover; 5 – lock nut; 6 – position sensor; « » – mark on ascend-
ing part of the cam; « » – mark on descending part of the cam.
Figure 3.15.7 – Installation and adjustment of "BOSCH" position sensor
To install the sensor
o raise the RLL to the extreme upper position;
o thread a positioning screw 7 (figure 3.15.8) into the rear axle cover 4 against the
stop, directing it to a hole "A" on a working surface of a cam 3;
o tighten a bolt 1; thread the positioning screw 7 out of the rear axle cover;
o screw the sensor 6 in until it stops against the cam, then turn it out by 1 rev. and lock
with a nut 5. If the sensor is installed correctly, the pilot lamp of the RLL uplift goes out as the
RLL reaches its extreme uplift position.
ATTENTION: OPERATION OF THE SENSOR
POSSIBLE ONLY IN A SET WITH A CAM OF "IZMERITEL" PLANT!
1 – bolt; 2 – turn shaft; 3 – cam; 4 – rear axle cover; 5 – lock nut; 6 – position sensor; 7 –
positioning screw; – installation hole.
Figure 3.15.8 – Installation and adjustment of position sensor

3.15.5.3 Force sensor installation

Force sensors 5 (figure 3.15.9) are executed as force-measuring pins, which are put
into a bracket 3 and serve as an attachment center for lower links 4. An angular position of the
pin in the bracket is determined by a clamp 1. The position sensor (pin) enters with its flat-
tened surfaces a groove of the clamp 1, secured on the bracket 3 with bolts 2.
1 – clamp; 2 – clamp mounting bolt; 3 – bracket; 4 – lower link; 5 – force sensor.
-01 of "Izmeritel" plant, proceed as follows:
Figure 3.15.9 – Force sensor installation
140
https://tractormanualz.com/
2022.3-0000010 OM
-01 OF "IZMERITEL" PLANT IS
-01 of "Izmeritel" plant