Procedure Of Filling With Water Or Water Solution; Order Of Partial Water Or Water Solution Drain From The Wheels Tires - Belarus 1822.3 Operator's Manual

5.12.5 Procedure of filling with water or water solution

Filling in of the liquid shall be carried out in the following order:
- jack the tractor;
- round the wheel 2 (Figure 5.12.1) in such way that the vent 1 is in the above posi-
tion;
- screw out the spool and insert in its place a compound "air-water" vent 2 (Figure
5.12.2), through which simultaneous filling in with water (solution) and tire venting is car-
ried out;
- perform filling in with water (solution);
- after filling in, withdraw the compound vent and screw in the spool, meanwhile ad-
just pressure to the standard tire operating pressure.
ATTENTION: WATER (SOLUTION)-FILLED TIRES PRESSURE SHALL BE
CHECKED ONLY WHEN THE VENT IN THE ABOVE POSITION OTHERWISE THE WA-
TER ENTERING THE TIRE PRESSURE GAUGE CAN RESULT IN PRESSURE GAUGE
FAILURE!
ATTENTION: FILL IN LIQUID ONLY INTO THE INNER TIRES OF THE DOUBLED
WHEELS AND FOR NOT MORE THAN 40% OF THE TIRE VOLUME!
Figure 5.12.1 – Position of the wheel during filling up of the liquid

5.12.6 Order of partial water or water solution drain from the wheels tires

For partial liquid drain the following shall be carried out:
- unload the wheel with liquid – jack the wheel in order it not to touch the ground;
- set the wheel in such a way that the vent is in the bottom;
- screw out the spool and drain the water or non-freezing solution up to the level of
vent positioned at the bottom.
1 – vent; 2 – wheel.
1 – tire; 2 – compound "air-water" vent
Figure 5.12.2 – Liquid filling-up scheme
222
https://tractormanualz.com/
2022.3-0000010 OM