Side Screens - Belarus 1822.3 Operator's Manual

1 - bolt; 2 – hinge; 3 – center support of cab frame; 4 – plane.
If necessary, the equal adjoining of the door to the door aperture can be achieved
by installation of additional plates 4 (figure 3.23.5) between the center support 3 of the cab
and the hinges 2.

3.23.4 Side screens

The side screens are open-type, hinged to the cab frame. The screen in open and closed
conditions is secured with a handle 1 (figure 3.23.6).
If necessary, the equal adjoining of the side glass to the window aperture is ensured
by installation of additional washers 3 between the screen and a bracket 4 of the screen
clamper.
1 – handle; 2 – center support of cab frame; 3 – washers; 4 – bracket.
For side screen position adjustment the following shall be done:
- take off a cap 5;
- loosen a nut 6;
- turning an eccentric bushing 4 (figure 3.23.7) find necessary screen position (be-
tween the side glass contour and the screen aperture contour a minimum positive clear-
ance shall make 2mm), tighten the nut 6, put the cap 5.
- for equal adjoining of the side screen to the window aperture change a quantity of
washers 1, installed between the screen 2 and the hinge 3.
1 – washer; 2 – screen; 3 – hinge; 4 – eccentric bushing; 5 – cap; 6 – nut, 7 –
rear support of cab frame; 8 – fixation pin.
Figure 3.23.5 – Door fastening to cab frame
Figure 3.23.6 – Fixation of side screen
Figure 3.23.7 – Side screen adjustment
159
https://tractormanualz.com/
2022.3-0000010 OM