Usage Peculiarities Of Special Low-Speed Modification Of 2022B.3 - 17/32; Maintenance; General Instructions - Belarus 1822.3 Operator's Manual

5.16 Usage peculiarities of special low-speed modification of 2022B.3 – 17/32
ATTENTION: ALL INFORMATION CONTAINED IN SECTION 5 "COUPLING OF
IMPLEMENTS" REGARDING COUPLING OF IMPLEMENTS WITH THE BASIC MODIFI-
CATION OF THE TRACTOR WILL ALSO APPLY TO THE LOW-SPEED MODIFICATION
WITH THE REVERSE CONTROL POST 2022 .3 - 17/32!
When selecting implements operating in the low-speed range define their operating
speed range and compare it with the tractor permissible speed. If you fail to do this then
later you might have problems with operation of the tractor coupled with the selected im-
plement.
When driving at low speeds drawbar pull of the tractor increases greatly. If you try to
use this increased drawbar pull for the increase of the tractor load, the tractor is very likely
to get broken.

6 MAINTENANCE

6.1 General instructions

Maintenance service (MS) is necessary for maintaining the tractor in operable state
during operational processes. Failure to observe the specified intervals of MS and bad
quality of MS may result in reduction of tractor life significantly, increase of failures, engine
power loss and increase in expenses for tractor operation. An operator shall carry out daily
inspection of the tractor, checking fasteners for tightening, fuel, liquid, and oil leakage, dirt
and other deposits accumulation, which can cause operating troubles, ignition or acci-
dents.
Notes about performance of maintenance services shall be made in the tractor ser-
vice book.
Observe storage precautions and waste recovery rules. Never discharge used liquid
to the ground. Use special tanks for safe storage of waste.
WARNING: WHILE CARRYING OUT MAINTENANCE AND REPAIR SERVICES, AL-
WAYS COMPLY WITH SAFETY PRECAUTIONS, LISTED IN SUBSECTION 6.6
"SAFETY PRECAUTIONS WHILE MAINTENANCE AND REPAIR SERVICES"!
ATTENTION: IF THERE ARE NO SPECIAL INSTRUCTIONS, BEFORE STARTING ANY
MAINTENANCE OR ADJUSTMENT SERVICES, ETC., STOP THE ENGINE AND EN-
GAGE PARKING BRAKES. IN CASE SAFETY GUARDS AND COVERS ARE OFF,
MAKE SURE THEY ARE MOUNTED BACK AFTER CONDUCTING MAINTENANCE
SERVICES, BEFORE YOU START OPERATING THE TRACTOR!
In the process of conducting maintenance services of the hydraulic lift system,
steering, and the transmission hydraulic system, it is strictly required to observe oil change
and filter replacement intervals. It is not allowed to use oil for filling (refilling), not specified
in the tractor operation manual.
Before refilling, replacing or cleaning filter cartridges, it is necessary to clean filler
plugs, necks and caps, and adjoining surfaces from dirt and dust. While filter cartridge re-
placement, wash internal surfaces of filter housings and caps with the diesel fuel.
While tractor coupling with hydraulically-operated implements, it is necessary to clean
clutches, couplings, adapting pipes and other connecting parts of the implement and the
tractor thoroughly.
In case the hydraulic system is operated with hydraulically-operated implements
filled with oil origin of which is unknown, the oil in the implement shall be replaced by the
oil filled into the tractor hydraulic lift system.
235
https://tractormanualz.com/
2022.3-0000010 OM