Depreservation And Represervation; Putting Tractor Into Operation After Long-Term Storage; Annex; (Compulsory) - Belarus 1822.3 Operator's Manual

It is required to clean tractor surfaces subject to preservation from mechanical stain-
ing, degrease it and dry up. It is required to cover unpainted inside and outside galvanized
surfaces, specific assemblies of tractor and cabin with corrosion-proof oil RUST BAN 397,
SUMIDERA 397.
Preservation of units (radiator and fuel tank filler, breathers, cylinder rods) shall be
carried out by means of casings made of polyethylene film.
The applied materials provide tractor protection and its assemblies for the period of
storage and transportation within one year.
Outside tractor and its assemblies preservation shall be made by lubrication of sur-
faces with a brush or sputtering by means of a paint sprayer. Inside tractor preservation is
carried out by filling cavities with preservation mixture and subsequent engine operation.
During tractor inter-shift, short-term and long-term storage, the enterprise operating
the tractor shall be responsible for compliance with preservation methods and storage
conditions specified in GOST 7751-85. Inside tractor surface preservation shall be carried
out with preservation grease
tractor is stored outside, specific surfaces shall be preserved with grease "BELA-COR" of
type " " according to TU RB 600125053-020-2004.

8.6 Depreservation and represervation

Depreservation method shall be chosen depending on preservation materials used.
Surfaces under preservation shall be wiped with cleaning cloth soaked with low-viscous
oils, solvents, or washed away with washing water-soluble detergents. Sealed assembles
shall be cleaned from insulation materials (film, paper). Inside surfaces under preservation
do not need depreservation.
Tractor represervation shall be carried out in case conservation defects are de-
tected in the process of storage or upon expiration of protection life.

8.7 Putting tractor into operation after long-term storage

Perform depreservation of the engine according to the engine operation manual
260S2 – 0000100 OM.
Remove grease from external surfaces under preservation. Dismount protective
covers, plugs, special accessories and mount the parts which were removed earlier back
in their places. Before mounting the parts, clean them off grease and dust. Drain sediment
out of all containers, fill them with operation fluids and if necessary, top up to the control
level.
Lubricate all tractor mechanisms according to clause 3 of table 6.4 of the present
operation manual. Carry out scheduled maintenance service. Run in the tractor for 15-20
minutes. Eliminate the detected faults.
according to TU RB 600125053.019-2004. When a
348
https://tractormanualz.com/
2022.3-0000010 OM