Maintenance Service That Does Not Coincide With Intervals Of Ms-1, 2Ms-1, Ms-2, Ms-3 And Special Ms; General Maintenance Services - Belarus 1822.3 Operator's Manual

1 – hatch cover; 2 – nut; 3 – stud pin; 4 – special nut; 5 – drive half coupling; 6 –
fuel pump drive gear.
ATTENTION: CHECK AND ADJUSTMENT OF FUEL INJECTION TIMING AD-
VANCE ADJUSTING ANGLE ON THE ENGINE SHALL BE CARRIED OUT ONLY BY
QUALIFIED SPECIALISTS!
On the engines
"YAZDA", fuel injection timing angle shall be 6±0,5 degrees of the crankshaft revolution to
the top dead center.
If your tractor is equipped with the fuel pump manufactured by "YAZDA", contact
your dealer for performing operations on check and adjustment of the fuel injection timing
angle on the engine.
6.4.7 Maintenance service that does not coincide with intervals of MS-1, 2MS-
1, MS-2, MS-3 and special MS
6.4.7.1 Operation 78. Change of the air-conditioning system filter-drier
Change of filter-drier shall be carried out in every 800 hours of operation or once a
year, whichever comes first.
ATTENTION: TO CHANGE A FILTER-DRIER, CONTACT SPECIAL SERVICE
STATION. CHANGE SHALL BE CARRIED OUT USING SPECIAL EQUIPMENT!

6.4.8 General maintenance services

6.4.8.1 General instructions
Maintenance service operations specified in subsection 6.4.8 shall be carried out as
required (i.e. according to the data of corresponding pressure or clogging indicators).
Figure 6.4.51 – Fuel pump drive
-260.4S2 and -260.9S2 with the fuel pump manufactured by
284
https://tractormanualz.com/
Hatch cover, pos.1, not shown
2022.3-0000010 OM