Service Brake Adjustment Of "Belarus-1822 .3/2022 .3 - Belarus 1822.3 Operator's Manual

3.8.5 Service brake adjustment of "BELARUS-1822 .3/2022 .3"

Adjust the service brakes of "BELARUS-1822 .3/2022 .3" in the following order:
- adjust and bleed the brakes for forward travel as specified in subsection 3.8.3
"Service brake adjustment of "BELARUS-1822.3/2022.3"
- adjust and bleed the brakes for reverse having previously checked and adjusted
the parking brake drive in accordance with the subsection 3.8.7 "Parking brake adjust-
ment"
ATTENTION: CARRY OUT ADJUSTMENT OF THE REVERSE ONLY AFTER IN-
SPECTION AND ADJUSTMENT OF SERVICE BRAKES FOR FORWARD TRAVEL AND
PARKING BRAKE DRIVE!
To adjust the brakes for reverse proceed as follows:
1. Check and if required set the dimension 33 2 mm (see the figure 3.8.7). To do
this undo the nut 8, do the thrust bolt 9 to a respective depth. Lock the nut 8.
2. Adjust free play of the pedal 1 (figure 3.8.7) within 6 to 12 mm, which corre-
sponds to the clearance of 1 to 2 mm between the pusher 4 of the master brake cylinder 3
and the piston 2. To do this, proceed as follows:
- unlock and remove the pin 7.
- remove the protective boot 10 and undo the lock nut 5 by several revolutions.
- doing the nut 6 on or off the pusher 4 set the pedal 1 free travel within the limits
specified above. The pedal free travel shall make 90 to 110mm;
- lock the nut 5 and forelock the pin 7.
1 – pedal; 2 – piston; 3 – master brake cylinder for reverse 4 – pusher; 5 – locknut;
6 – fork; 7 – pin; 8 – nut; 9 – bolt; 10 – boot.
Figure 3.8.7 – Adjustment of service brakes of BELARUS-1822 .3/2022 .3 for re-
verse
108
https://tractormanualz.com/
2022.3-0000010 OM