Selection Of Implements For Coupling; General Instructions; Methods Of Selection Of The Implements For Coupling - Belarus 1822.3 Operator's Manual

5.6. Selection of implements for coupling

5.6.1 General instructions

ATTENTION: IMPLEMENTS OF IDENTICAL APPLICATION BUT OF VARIOUS
MANUFACTURERS MAY DIFFER IN COUPLING CHARACTERISTICS, HAVE VARIOUS
TECHNICAL CHARACTERISTICS AND REGULATIONS. WHEN SELECTING AN IM-
PLEMENT PAY SPECIAL ATTENTION TO VARIABLE CHARACTERISTICS OF WORK-
ING CONDITIONS OF THE IMPLEMENTS IN FIELD CONDITIONS!
In the operation documentation of the implements not only matters of accurate ap-
plication of the implements for the purpose specified are considered, but also guidelines
about selection and coupling of the tractor implements are made. Anyway the manufac-
turer (seller) of the implement shall give on your request the information on the minimum
basic characteristics of the tractor which shall ensure possibility of the implements cou-
pling.
To make the machine and tractor unit (
fine, how many machines and with what performance characteristics are required for cou-
pling with your tractor, what type of hitch should be applied when required, what additional
working attachments should be used, what adjustments and customizations should be
made, and what gear it should work in. But for this purpose you need to buy implements at
first. An order of units assembly based on a tractor, and features of operation are specified
in manuals for equipment coupled. In all cases it is necessary to check up conformity ac-
cording to connecting components, lifting capacity of lift linkages and tires, a permissible
load on DH and tractor axles.
Tractors "BELARUS-1822.3/1822 .3/2022.3/2022 .3" work with tilling machine with
average resistance of working attachment of 30.0 N. Unit grasp width and processing
depth basically depend on unit drafts of soils determining a range of working speeds with
regard to agricultural requirements. The more soil is heavy textured, the higher the resis-
tance is. Change of speed by 1 km/h results in unit draft change by 1 ... 2 %.
ATTENTION: IT IS VERY IMPORTANT TO RECEIVE FROM THE MANUFAC-
TURER (SELLER) OF THE IMPLEMENT THE SUFFICIENT INFORMATION ON TRAC-
TOR PERFORMANCE WHICH WILL ENSURE OPERATION OF THE IMPLEMENT. IF
SUCH INFORMATION WAS NOT PRESENTED, IT IS RECOMMENDED NOT TO OP-
ERATE (NOT TO BUY) SUCH IMPLEMENT TO AVOID POSSIBLE SERIOUS PROB-
LEMS DURING OPERATION WHICH MAY RESULT IN TRACTOR FAILURE!

5.6.2 Methods of selection of the implements for coupling

There are the following methods of selection of the implements for coupling:
- calculating method;
- experimental method
U) on the basis of a tractor means to de-
205
https://tractormanualz.com/
2022.3-0000010 OM