3.23.4 Installation and adjustment of speed sensors and
rear PTO RPM sensor
3.23.4.1 Speed sensor installation
For installation of speed sensor (either right or left) the following shall be done:
- put toothed disc 8 (figure 3.23.4) with tooth against the hole in semi axle tube 7;
- it is necessary to put necessary quantity of shim washers 6 according to the table
3.6 to ensure free play S;
- put "mass" wire 3 of the sensor 2 under any of screws 4;
- seal the screws 4 with sealing paste and tighten with the moment 10...15Nm.
1 – gasket; 2 – speed sensor; 3 –"mass" wire; 4 – screw М8; 5 – washer; 6 – shim
washer in thickness of 1 mm; 7 – semi axle tube; 8 – toothed disc.
Figure 3.23.4 – Installation of speed sensor
Table 3.6 – Speed sensor installation
Q-ty of
gaskets 6
H, mm
(figure 3.23.4)
53,5 – 54,8
54,9 – 55,8
55,9 – 56,5
196
https://tractormanualz.com/
S, mm
3
1,5 – 2,8
2
1,9 – 2,8
1
1,9 – 2,8
3522.5-0000010 РЭ